On both link sides unpack the device, check its condition and completeness. Mount the device to the antenna handle. Screw the device mounting handle according to attached instruction (with care).
First link side (side A):
Power on the power supply. Connect the "Device" port with Miure Duo, and "Ethernet" with a laptop.
Configure the IP address of your laptop as "192.168.1.10/24" (mask 255.255.255.0). Open your browser (Mozilla Firefox recommended) and type "192.168.1.1" in the address bar. Login using "admin" as both the username and password.
On the "Basic" tab type "192.168.1.2/24" in the "IP address" option and click outside of the text field - the value should be accepted and both the green and blue LEDs should become turned on.
Click "Apply" in the upper left corner and without waiting for confirmation point your browser at "192.168.1.2". Use the same login and password as in p. 2.2.b.
Click the "Radio parameters" tab and ensure that "A" is selected in "Link side". Enter any unique text in "Unique link name" and check configuration under "Radio transmission".
In the upper left corner click "Apply" and wait until "Status: ready" appears in the bottom status bar. Click "Save".
First link side (side B):
Power on the power supply. Connect the "Device" port with Miure Duo, and "Ethernet" with a laptop.
Configure the IP address of your laptop as "192.168.1.11/24". Open your browser and type "192.168.1.1" in the address bar. Login using "admin" as both the username and password.
Click the "Radio parameters" tab and select "B" in "Link side". In all remaining fields enter the same values as in p 2.2.e. (especially in "Unique link name").
In the upper left corner click "Apply" and then "Save" (as in p. 2.2.f). The devices should connect.
In case of very long distance links it may be necessary to decrease the channel width to 10MHz or even 5MHz. In order to do that, use the "Radio parameters" tab.
On both link sides select "Link quality" from menu on left and enable the antenna alignment mode by clicking the checkbox below the graph.
WARNING: the antenna alignment mode does not turn off automatically
Loosen up the mounting handle a bit and try to select such antenna direction, so the remote signal strength (blue color) is the greatest. Adjust only one antenna at the same time.
After aligning the antennas, finally tighten up the mounting handle, turn off antenna alignment mode and wait for about 60 seconds, to let devices enter the normal operation mode for the first time.
Devices are ready for configuration, what may be done remotely. Enter desired IP addresses on both sides (remembering about applying and saving the changes) and connect them to the network.